| | |
|
| |
| | |
|
Our own guides to hand dryers and other restroom equipment.
|
|
Xlerator Series Hand Dryers
 Excel Dryer Xlerator Excel Dryer Xlerator XL- C (Chrome) Excel Dryer Xlerator XL- GR (Textured Graphite) Excel Dryer Xlerator XL- SB (Stainless Steel) Excel Dryer Xlerator XL-W (White Enamel on Steel) |
|
RESTROOM DIRECT PRICE: From $400.00 to $540.00
Product Options
| |
| |
|
  TO SEE PRICE, select options above!
Need your Xlerator in a hurry? Use coupon code "xlerator" to get FREE 2ND DAY SHIPPING via Fedex.
Offer not valid for other hand dryer models. For free Ground shipping, no coupon is required - you will see estimated delivery
time when checking out. Please use Fedex Ground when you can receive your shipment between 2 and 5 business days.
Restroom Direct has the guaranteed lowest Xlerator prices.
The Xlerator by Excel Dryer Inc. is the original and premier high speed hand dryer.
Feel the Power.
Features
• Dries Hands Completely in 10 to 15 Seconds
• Uses 80% Less Energy
• 95% Cost Savings vs. Paper Towels
• GREENSPEC® Approved and Helps Qualify for LEED® credits.
• Source Reduction Alternative
• Promotes Hygiene
Specifications
Unit Measurements: 11 3/4" LG. X 12 11/16" HIGH X 6 11/16" DEEP
(298 MM LG. X 322 MM HIGH X 170 MM DEEP)
Weight: 16 LBS. (7.3 KGS.)
Power: 1500 watts
Construction
Hand dryer cover shall be a one-piece, heavy-duty, rib-reinforced, die-cast zinc alloy. It shall be lightweight, unbreakable, rustproof and all exposed surfaces shall be bright chrome plated or finished with chip-proof, electrostatically applied epoxy paint and fastened to a wall plate by two chrome plated tamper-proof bolts.
Hand dryer wall plate shall be equipped with (3) 7/8" (22 mm) diameter holes, one of which shall be suitable for use with surface conduit, for ease of wiring.
All internal hand dryer parts shall be coated according to Underwriters' Laboratories, Inc. requirements.
Entire mechanism shall be internally grounded.
Mechanism
Hand dryer motor shall be a series commutated through-flow discharge vacuum motor/blower (5/8 HP / 20,000 RPM) which provides air velocity of 16,000 LFM (linear feet per minute) at the air outlet and 14,000 LFM at the hands (4 inches [102 mm] below air outlet).
Hand dryer heating element (900 W) is constructed of Nichrome wire and mounted inside the blower housing, thereby being vandal proof. It shall be protected by an automatic resetting thermostat, which shall open whenever air flow is cut off and shall close when flow of air is resumed. It shall produce an air temperature of up to 135°F (57°C) at a 72°F (22°C) ambient room temperature at the hands (4 inches [102 mm] below air outlet).
Hand dryer Control assembly is activated by an infrared optical sensor located next to the air outlet. The dryer shall operate as long as hands are under the air outlet. There is a 35-second lockout feature if hands are not removed.
Limited Warranty
The hand dryer shall be guaranteed to be free from defects for a period of five (5) years. Warranty shall include factory performed labor as well as the repair or exchange of defective parts, at manufacturer's option.
 Please note, there is no difference between Xlerator models other than the cover material an voltage. The hand dryers should all function the same no matter the voltage.Your choice of volts does not affect the price, however your choice of cover material does.
|
|
|
|
|
|
|
Cover Options
|
110/120 volts
|
208 volts
|
277 volts
|
220/240 volts
|
|
White, Die Cast Zinc
|
XL-W
|
XL-W8
|
XL-WX
|
XL-WV
|
|
White, Thermoset Polymer
|
XL-BW
|
XL-BW8
|
XL-BWX
|
XL-BWV
|
|
Textured Graphite, Die Cast Zinc
|
XL-GR
|
XL-GR8
|
XL-GRX
|
XL-GRV
|
|
Chrome, Die Cast Zinc
|
XL-C
|
XL-C8
|
XL-CX
|
XL-CV
|
|
Stainless Steel, Brushed
|
XL-SB
|
XL-SB8
|
XL-SBX
|
XL-SBV
|
Case Studies
Downloads:
Xlerator Hand Dryer Rough-In Diagram:
Xlerator hand dryer wiring diagram for 110 through 240 volt units:
Note: For 110 / 120 volts, L2 is neutral, L1 is live. For 208 and 220 / 240 volt Xlerator hand dryers, L1 and L2 are BOTH live (in no particular order) and a neutral line is not necessary. In that case the white wire can be capped if you have one.
Xlerator hand dryer 277 volt wiring diagram:
Note that the sensor on the Xlerator hand dryer is adjustable. Look for a white nob on the right side of the control assembly. If you turn it counter-clockwise you will make the sensor less sensitive. If you are experiencing "ghosting" with this hand dryer - that's when the hand dryer goes off when hands are not present - then you want to be sure that the hand dryer is not located too close to a shiny surface such as a counter or a floor. Adjusting the sensor may help this. If it does not, then there may be an electrical impulses creating an interference. In the case of an electrical interference, Excel Dryer can replace the board for you to try to fix this. Please call them directly at 413-525-2853.
Other models similar to the Xlerator :EHD-501, EHD-502, EHD-503, EHD-504, 2KJJ8, 2KJJ9, 3DYHD3
|
RESTROOM DIRECT PRICE: From $300.00 to $390.00
Excel's Hands On hand dryers boast a longstanding reputation for quality and reliability. The Hands On hand dryer series offers a choice of surface or recessed wall mounting.
|
RESTROOM DIRECT PRICE: From $330.00 to $420.00
Excel's Hands Off hand dryers provide exceptionally quiet operation with maximum strength and durability. Performance is backed by a Ten Year Limited Warranty on the hand dryers (three years on control assembly and sensor).
|
RESTROOM DIRECT PRICE: From $200.00 to $230.00
Lexan Series white, surface-mounted hand dryers are economical, durable and vandal resistant. Backed by US manufacturer Excel Dryers.
|
Retail Price: $160.00
RESTROOM DIRECT PRICE: $144.00
Brushed stainless steel recessing kit for the Excel Xlerator hand dryer. Recess this kit into the wall; mount the Xlerator in the wall box for an ADA compliant depth of about 3 7/8" from the wall. Hand dryer sold separately.
|
RESTROOM DIRECT PRICE: From $340.00 to $484.00
Brushed stainless steel recessing
kit for replacing a traditional
paper towel dispenser with an
Excel Xlerator hand dryer.
|
Retail Price: $700.00
RESTROOM DIRECT PRICE: $440.00
The XL-W, white die cast zinc, epoxy coated hand dryer is the standard and most popular Xlerator hand dryer model. Feel the Power!
|
Retail Price: $760.00
RESTROOM DIRECT PRICE: $540.00
The Stainless steel cover option is beautiful, matches well with other stainless in the restroom, is easy to clean and maintain, and is vandal resistant. Brushed stainless steel hides fingerprints and scratches.
|
Retail Price: $700.00
RESTROOM DIRECT PRICE: $480.00
The black, textured graphite is one of the most attractive cover options on the Xlerator hand dryer. Feel the power! See the beauty!
|
Retail Price: $700.00
RESTROOM DIRECT PRICE: $480.00
The sleek black cover option
on the Xlerator hand dryer.
Feel the power! See the beauty!
|
RESTROOM DIRECT PRICE: From $24.00 to $195.00
Certified XLERATOR HEPA
Filtration Retro-fit kit, HEPA
Filter, Metal Mesh pre-filter.
| | |
|
|